Oakberry Lane Seesaw Card

New on the Heartfelt Creations Blog today. The very cute 
Oakberry Lane Collection. Hope you enjoy my Seesaw card.

Heartfelt Creations products used

HCD17199 Oakberry Lane Antics Die
HCPC3841 Oakberry Lane Antics Cling Stamp Set
HCPC3840 Oakberry Cottage & Sentiments Cling Stamp Set
HCDP1294 Oakberry Lane Paper Collection
HCD17155 Circles Basics Large Die
TSMP808 Memento Espresso Truffle

159723 Designer Dries Clear Adhesive
DDOTS - Double Dots 100pc-3D Foam Circles
HCST1401 Deluxe Flower Shaping Kit

Other products used

Mauve sheer ribbon
White Cardstock
Diamond Stickles
Glossy Accents
Copic Markers - E50 E51 E31 E33 R20 critters, E33 Seesaw, E71 E50 Nut, W1 tyres, R20 flowers, G21 grass and ribbons.

Instructions

Cut your card base 6" x 6". Cut your patterned mat 5 3/4" x 5 3/4", die cut out the center with your largest die from your Circle Basics die set. Adhere the mat to your card front and then using the same die cut out the white center of the card. With your aperture cut line up your patterned circle and adhere to the inside of your card.

Stamp your seesaw using Memento Espresso Truffle using your Oakberry Antics stamp set, color with your copics or pen or pencil of choice. Cut with coordinating die, die cut a second image just using white cardstock, adhere together for a stronger die cut, you will need to fussy cut of the bottom of the seesaw, only the stem section leave the circle section intact. Fussy cut of the tyre and keep this will be adhered later. Just ink up the middle of the stamp and stamp a seesaw base and also cut a second one on white cardstock to adhere together to make a stronger diecut. Fussy cut out the bottom of the seesaw leaving the circle section on top. Apply an eyelet to each circle section of the seesaw, so they line up. You will put this together with a brad and this will allow your seesaw to move.

Using the white lace border from  your Oakberry paper collection cut a border strip and adhere between the purple section. Adhere your seesaw (only the base section) with designer dries clear adhere to the front of the card (along the lace line,this will allow your seesaw to move. Using 3d dots to adhere your tyres on the left and right side, this will act as a stopper for your seesaw.

Using your sheer ribbon tie and bow and adhere at the top of your aperature. Decorate with stickles and glossy accents as desired.

Happy Crafting
Tracy x x