Winters Eve

Materials

Winters Eve Stamp HCPC3796
Window Box Fillers HCPC3795
Window Frame Stamp HCPC3794
Window Box Fillers Die HCD17150
Window Frame Die HCD17148
Window Box Elements HCD17150
Memento Ink Tuxedo Black (stamping)
White card for stamping/die cutting
Copic YG63 or YG67 (leaves)
Copic R24 or R27 (flowers/berries
Copic E33 or E35 or E37 (branches)
Bazzill Crimson 30cm x 15cm (1)
Distress Glitter Rock Candy
Winters Eve Paper Pad 14.5cm x 14.5cm (3)

CardAssembly                                                                                                                                                      

Colour Colour your Berries using either your R24 or R27 copic pen. Colour your leaves using either YG63 or YG67 copic pen. Colour your branches using either E33, E35, E37 copic pen. Fold your base card in half, adhere your church mat to the front of the card and adhere your remaining two mats to the inside of your card as pictured above. Using your die cut window frame, adhere your first piece of acetate flat to the back of the window.  Adhere your foam tape around the window opening as pictured, pour in your glitter and adhere your other piece of acetate to seal your shaker card shut. Adhere your decorative die cut piece onto the card first (this will sit on the top of the window) and then using 3d foam again adhere your window to your card front as pictured. Adhere your flowers (cut into single flowers), branches and twig as desired or as pictured. Trim your sentiment in to a tag, so a point on the left and a tail on the right and then using 3d foam only on the end of your sentiment tag and then a dot of glue on the point of the tag adhere to the bottom right of the window as pictured. Apply Nuvo Crystal Glaze or Glossy accents to your berries. Using a Wink of Stella Clear or a Nuvo glitter brush pen highlight your holly leaves. Apply glitter to your card as desired for a snow effect.